C1126 NISSAN - Rear Right Input ABS Solenoid
- Faulty ABS Actuator/Electric Unit
- ABS Actuator/Electric Unit harness is open or shorted
- ABS Actuator/Electric Unit poor electrical connection
It is much more difficult to diagnose a problem that occurs intermittently rather than continuously. Most intermittent problems are caused by poor electrical connections or faulty wiring. In this case, careful checking of suspicious circuits may help prevent the replacement of good parts.
There is a factory service bulletin for the following Nissan models:
2004 Nissan Maxima
2005 Nissan Maxima
2006 Nissan Maxima
2007 Nissan Maxima
When is the code detected?
- Anti-Lock Brake System (ABS) Warning Light ON
C1126 NISSAN Description
The control unit computes the wheel rotating speed by the signal sent from the sensor. Then it supplies a DC current to the actuator solenoid valve. It also controls ON-OFF operation of the solenoid valve relay and motor relay. If any electrical malfunction should be detected in the system, the control unit causes the warning lamp to turn on. In this condition, the ABS will be deactivated by the control unit, and the vehicle's brake system reverts to normal operation.
The ABS actuator and electric unit (control unit) contains: An electric motor and pump, Two relays, Eight solenoid valves ( each inlet and outlet for LH front, RH front, LH rear, RH rear), and ABS control unit.
These components control the hydraulic circuit that increases, holds or decreases hydraulic pressure to all or individual wheels. The ABS actuator and electric unit (control unit) cannot be disassembled and must be replaced as an assembly.
Need more help?
C1126 NISSAN CommentsHelp us improve itimaster.ru. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the C1126 Nissan code? Have you replaced any parts?
Any information is appreciated. Thanks